View MX23L1610_168426.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

MX23L1610
3.3 Volt 16-Mbit (2M x 8 / 1M x 16) Mask ROM
FEATURES
* Bit organization - 2M x 8 (byte mode) - 1M x 16 (word mode) * Fast access time - 70ns (max.)@3.3V10% * Current - Operating:25mA - Standby:15uA * Supply voltage - 3.0V ~ 3.6V * Package - 44 pin SOP (500mil) - 42 pin DIP (600mil) - 48 pin TSOP (12mm x 20mm) - 44 pin TSOP (Type II)
ORDER INFORMATION
Part No. MX23L1610MC-70 MX23L1610MC-90 MX23L1610MC-10 MX23L1610MC-12 MX23L1610MC-15 MX23L1610PC-10 MX23L1610PC-12 MX23L1610PC-15 MX23L1610TC-70 MX23L1610TC-90 MX23L1610TC-10 MX23L1610TC-12 MX23L1610TC-15 MX23L1610RC-10 MX23L1610RC-90 Access 70ns 90ns 100ns 120ns 150ns 100ns 120ns 150ns 70ns 90ns 100ns 120ns 150ns 100ns 90ns 120ns 150ns 120ns 100ns 120ns 150ns Package 44 pin SOP 44 pin SOP 44 pin SOP 44 pin SOP 44 pin SOP 42 pin PDIP 42 pin PDIP 42 pin PDIP 48 pin TSOP 48 pin TSOP 48 pin TSOP 48 pin TSOP 48 pin TSOP 48 pin TSOP (Reverse type) 48 pin TSOP (Reverse type) 48 pin TSOP (Reverse type) 48 pin TSOP (Reverse type) 48 pin TSOP 44 pin TSOP 44 pin TSOP 44 pin TSOP
PIN CONFIGURATION
MX23L1610RC-12 44 SOP/44 TSOP
NC A18 A17 A7 A6 A5 A4 A3 A2 A1 A0 CE VSS OE D0 D8 D1 D9 D2 D10 D3 D11 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 44 43 42 41 40 39 38 37 36 35 34 33 32 31 30 29 28 27 26 25 24 23 NC A19 A8 A9 A10 A11 A12 A13 A14 A15 A16 BYTE VSS D15/A-1 D7 D14 D6 D13 D5 D12 D4 VCC
42 PDIP
A18 A17 A7 A6 A5 A4 A3 A2 A1 A0 CE VSS OE D0 D8 D1 D9 D2 D10 D3 D11 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 42 41 40 39 38 37 36 35 34 33 32 31 30 29 28 27 26 25 24 23 22 A19 A8 A9 A10 A11 A12 A13 A14 A15 A16 BYTE VSS D15/A-1 D7 D14 D6 D13 D5 D12 D4 VCC
MX23L1610RC-15 MX23L1610TI-12* MX23L1610YC-10 MX23L1610YC-12 MX23L1610YC-15
MX23L1610
MX23L1610
*Note:Temperature: -40~85C
PIN DESCRIPTION
Symbol A0~A19 D0~D14 D15/A-1 CE OE Byte VCC VSS NC Pin Function Address Inputs Data Outputs D15 (Word Mode)/ LSB Address (Byte Mode) Chip Enable Input Output Enable Input Word/ Byte Mode Selection Power Supply Pin Ground Pin No Connection
REV. 2.5, AUG. 15, 2001
P/N:PM0243
1
MX23L1610
48 TSOP (Normal Type)
BYTE A16 A15 A14 A13 A12 A11 A10 A9 A8 A19 VSS NC A18 A17 A7 A6 A5 A4 A3 A2 A1 A0 CE 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 48 47 46 45 44 43 42 41 40 39 38 37 36 35 34 33 32 31 30 29 28 27 26 25 VSS VSS D15/A-1 D7 D14 D6 D13 D5 D12 D4 VCC VCC NC D11 D3 D10 D2 D9 D1 D8 D0 OE VSS VSS
MX23L1610 (Normal Type)
48 TSOP (Reverse Type)
VSS VSS D15/A-1 D7 D14 D6 D13 D5 D12 D4 VCC VCC NC D11 D3 D10 D2 D9 D1 D8 D0 OE VSS VSS 48 47 46 45 44 43 42 41 40 39 38 37 36 35 34 33 32 31 30 29 28 27 26 25 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 BYTE A16 A15 A14 A13 A12 A11 A10 A9 A8 A19 A21 A20 A18 A17 A7 A6 A5 A4 A3 A2 A1 A0 CE
MX23L1610 (Reverse Type)
MODE SELECTION
CE H L L L OE X H L L Byte X X H L D15/A-1 X X Output Input D0~D7 High Z High Z D0~D7 D0~D7 D8~D15 High Z High Z D8~D15 High Z Mode Word Byte Power Stand-by Active Active Active
BLOCK DIAGRAM
A0/(A-1) A19
Address Buffer
Memory Array
Page Buffer
Page Decoder
Word/ Byte
Output Buffer
D0 D15/(D7)
CE BYTE OE
P/N:PM0243
REV. 2.5, AUG. 15, 2001
2
MX23L1610
ABSOLUTE MAXIMUM RATINGS
Item Voltage on any Pin Relative to VSS Ambient Operating Temperature Storage Temperature Note: Symbol VIN Topr Tstg Ratings -0.3V to 4.3V 0 to 70 C C -65 to 125 C C
Minimum DC voltage on input or I/O pins is -0.5V. During voltage transitions, inputs may undershoot VSS to -1.3V for periods of up to 20ns. Maximum DC voltage on input or I/O pins is VCC+0.5V. During voltage transitions, input may overshoot VCC to VCC+2.0V for periods of up to 20ns.
DC CHARACTERISTICS (Ta = 0C ~ 70C, VCC = 3.0V~3.6V)
Item Output High Voltage Output Low Voltage Input High Voltage Symbol VOH VOL VIH MIN. 2.4V 2.2V MAX. 0.4V VCC+0.3V* Conditions IOH = -400uA IOL = 1.6mA MAX. number:VCC+0.3V is under normal operation mode, and VCC+0.7V is under non-operating mode 0V, VCC 0V, VCC tRC = 120ns, all output open CE = VIH CE>VCC-0.2V Ta = 25 f = 1MHZ C, Ta = 25 f = 1MHZ C,
Input Low Voltage Input Leakage Current Output Leakage Current Operating Current Standby Current (TTL) Standby Current (cmos) Input Capacitance Output Capacitance
VIL ILI ILO ICC1 ISTB1 ISTB2 CIN COUT
-0.3V -
0.2 x VCC 5uA 5uA 25mA 0.5mA 15uA 10pF 10pF
AC CHARACTERISTICS (Ta = 0 ~ 70C, VCC = 3.0V~3.6V) C
Item Read Cycle Time Address Access Time Chip Enable Access Time Output Enable Time Output High Z Delay Symbol 23L1610-70 MIN. tRC tAA tACE tOE tHZ 70ns 0ns MAX. 70ns 70ns 35ns 20ns 23L1610-90 MIN. 90ns 0ns MAX. 90ns 90ns 45ns 20ns 23L1610-10 MIN. 0ns MAX. 100ns 100ns 50ns 20ns 100ns 23L1610-12 MIN. 120ns 0ns MAX. 120ns 120ns 60ns 20ns 23L1610-15 MIN. 0ns MAX. 150ns 150ns 70ns 20ns 150ns -
Output Hold After Address tOH
Note:Output high-impedance delay (tHZ) is measured from OE or CE going high, and this parameter guaranteed by design over the full voltage and temperature operating range - not tested.
P/N:PM0243 REV. 2.5, AUG. 15, 2001
3
MX23L1610
AC Test Conditions
Input Pulse Levels Input Rise and Fall Times Input Timing Level Output Timing Level Output Load 0.4V~ 2.4V 10ns 1.4V 1.4V See Figure
IOH (load)=-0.4mA DOUT IOL (load)=1.6mA
C<100pF
Note: No output loading is present in tester load board. Active loading is used and under software programming control. Output loading capacitance includes load board's and all stray capacitance.
TIMING DIAGRAM
RANDOM READ
ADD
ADD
tACE
ADD
tRC
ADD
CE
tOE
OE
tAA tOH tHZ
DATA
VALID
VALID
VALID
Note:CE, OE are enable
P/N:PM0243
REV. 2.5, AUG. 15, 2001
4
MX23L1610
PACKAGE INFORMATION
42-PIN PLASTIC DIP(600 mil)
P/N:PM0243
REV. 2.5, AUG. 15, 2001
5
MX23L1610
44-PIN PLASTIC SOP
P/N:PM0243
REV. 2.5, AUG. 15, 2001
6
MX23L1610
48-PIN PLASTIC TSOP
P/N:PM0243
REV. 2.5, AUG. 15, 2001
7
MX23L1610
44-PIN TSOP (Type II)
P/N:PM0243
REV. 2.5, AUG. 15, 2001
8
MX23L1610
REVISION HISTORY
REVISION 1.9 DESCRIPTION 1. Package Type:Add 42-PDIP package type. 2. DC Characteristics:The input low voltage VIL Max. value is changed as 0.2xVCC instead of 0.8V. 3. AC Characteristics:The output high Z delay is changed as 20ns instead of 70ns. 4. Add 105ns speed grade. 5. Add 100ns speed grade @3.3V5% 6. AC Test Conditions:The output timing level is changed as 1.4V instead of 0.8V and 2.0V. AC CHARACTERISTICS tOH 10ns-->0ns Typing error correction 1.Added 44-pin TSOP (Type II) Package 2.Modify Package Information 1.Add 90ns speed grade 2.Delete 105ns speed grade 1.Added 70ns speed grade Change VOH(MIN.):2.3V-->2.4V; VIH(MIN.):2.1V-->2.2V PAGE DATE JUN/11/1998
2.0 2.1 2.2 2.3 2.4 2.5
P4 P1 P1,8 P5~7 P1,3 P1,3 P1,3 P3
FEB/01/1999 JAN/18/2000 JUL/18/2001 JUL/31/2001 AUG/14/2001 AUG/15/2001
P/N:PM0243
REV. 2.5, AUG. 15, 2001
9
MX23L1610
MACRONIX INTERNATIONAL CO., LTD.
HEADQUARTERS:
TEL:+886-3-578-6688 FAX:+886-3-563-2888
EUROPE OFFICE:
TEL:+32-2-456-8020 FAX:+32-2-456-8021
JAPAN OFFICE:
TEL:+81-44-246-9100 FAX:+81-44-246-9105
SINGAPORE OFFICE:
TEL:+65-348-8385 FAX:+65-348-8096
TAIPEI OFFICE:
TEL:+886-2-2509-3300 FAX:+886-2-2509-2200
MACRONIX AMERICA, INC.
TEL:+1-408-453-8088 FAX:+1-408-453-8488
CHICAGO OFFICE:
TEL:+1-847-963-1900 FAX:+1-847-963-1909
http : //www.macronix.com
MACRONIX INTERNATIONAL CO., LTD. reserves the right to change product and specifications without notice.
10

▲Up To Search▲

Price & Availability of MX23L1610

	To Download MX23L1610 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .